Download Print this page

Hobby-Fab R7 Build Instructions page 10

Advertisement

Last updated: 08/13/20108
Rev. 9
Step 3:
Step three will be the assembly of the rear X gantry plate. The same principles apply here. Use the
reference wheels as a base and adjust the eccentrics to touch the inside of the sample beam (250mm
length Z). Continue by installing the ACME block with the supplied 3mm spacers and M5 x 20mm bolts.
Again, it is a good idea to adjust the tension on the ACME block at this time.
Note this plate is completely remodeled but the assembly remains the same.
10

Advertisement

loading