Advertisement
Step 9: Let us add some peripherals.
Step 9
3/16" ID 5/16" OD vinyl tubing
4 pole wire 18 to 22g
3 pole wire (typically 16g)
15mmx30mm cable chain
M5 drop-in T-nut
M5 x 10mm bolt
9mm spacer
Water pump
M5x20mm bolt
Sheathing 10mm
M5 x 25mm bolt
Figure out where you want your electronics and water reservoir. It is highly advised they are not in the
same location.
Run the cable chain down either the left or right side of the build. Mount one end to the y gantry plate.
One plate will have a threaded hole in the middle of the hobby-fab logo, this is for the Y cable chain.
Reduce the Y cable chain to half the shipped length. You will need to remove one end of the cable chain.
If you remove the proper end, you will be left with a hole in the side of the cable chain where the mount
end was "tabbed" in. Use this hole, a 9mm spacer, and M5x20mm bolt. Mount this end upside down
and cable chain extending facing the front. Mount the other end right side up with a wood screw to the
spoiler board, again aimed towards the front.
Qty
Smw3d
30
36
18
2
1
1
2
1
1
10
1
Last updated: 08/13/20108
Builder
Rev. 9
29
Advertisement
