Table of Contents
Advertisement
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the ,Intensive‐
Cooling or after changing
the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig‐
erator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The IntensiveCooling func‐
tion is switched on.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The IntensiveCooling func‐
tion is switched on.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Contact the nearest Au‐
thorized Service Centre.
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door".
Refer to "IntensiveCooling
function".
The compressor starts af‐
ter a period of time.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Switch off IntensiveCooling
manually, or wait until the
function resets automati‐
cally to set the tempera‐
ture. Refer to "Intensive‐
Cooling function".
Set a higher/lower temper‐
ature.
11
Advertisement
Table of Contents
