Table of Contents
Advertisement
2
2
CHAPTER TWO
Remote Control and On-Screen Menus
Remote Control
Ô SELECT
Press to choose a particular component to be controlled by the
remote. When you press SELECT, a green light will blink under the
component that is being controlled (DTV, TV, VCR, CATV, or DVD).
See "Programming the Remote Control," below.
#2
TV/VIDEO
Press to view the signal sources that are available for display on
your TV.
Ò PRE-CH (Previous Channel)
Press to alternate between the current channel and the last channel
that was displayed.
#2
Ú MUTE
Press to temporarily cut off the sound.
Æ CAPTION
When a digital signal is received, only available languages can be
selected. When an analog signal is received, either CC1, CC2, CC3
CC4 can be selected.
ı CH
,
(Channel Up and Down)
Press to change channels.
˜ ENTER
While using the on-screen menus, press ENTER to activate (or
change) a particular item.
¯ MENU
Press to display the on-screen menus, or to switch back to the pre-
vious menu-screen that was displayed.
˘ GUIDE
Press to display the on-screen, Electronic Program Guide (EPG).
¿ I-Point control
Use to move the on-screen pointer left, right, up or down.
¸ EXIT
Press to completely exit all the on-screen menus.
#3, #5
˛ PLAY
Press to play a videocassette or DVD.
◊ FF (Fast Forward)
Press to fast forward a videocassette or forward search a DVD.
± SET
Use to program the remote control for other components.
(See to Operate other components, page 4.11)
2.2
#1
#1, #2, #3, #4
#3, #5
Advertisement
Table of Contents
