Turning On Your Sicare Pilot; Operating Your Sicare Pilot In The Holder - Tash SICARE Pilot User Manual

5
evo soft
@
SICARE Pilot - User Manual

4. Turning on your SICARE Pilot

When the SICARE Pilot is turned on ¶, the device is in stand-by mode. Pressing the
SCROLL key or the OK key ¹ starts the device. After briefly showing the software
version on the display, the first word of the main-menu level is shown in the first line of
the display.
The SICARE Pilot is delivered with 2 empty rechargeable batteries. These must be
charged for at least 3 hours, before a configuration from the PC can be transferred into
the SICARE Pilot!
Failing to pay attention to this can put your SICARE Pilot into an errant condition
which can only be corrected at the factory!

5. Operating your SICARE Pilot in the holder

Operation in the holder is done for the following reasons:
• To operate your SICARE Pilot using the mains
• To charge the rechargeable batteries
• For exchanging data between a PC and the SICARE Pilot
• For teaching the speech samples for operation of the SICARE Pilot by voice
To assemble the base of the holder to the foot base:
1. Place the square bolt into the horizontal slit on the back of the holder.
2. Connect the foot base to the holder using an allen screw.
Place the SICARE Pilot in the holder, until the plastic tip on the cover of the battery
holder snaps into the hold in the holder.
For easier removal of the SICARE Pilot from the holder, press the sides of the holder
lightly together and pull the SICARE Pilot out of the holder.
ATTENTION !
Version 4.1
.
International Inc
User Manual / Page 6