Makita 4341CT Hardware Technical Information page 4

R
epair
< 5 > Disassembling gear housing cover section
1.After taking off safety wire from gear housing cover, unscrew 4 pcs. of tapping screws CT 4 x 16.
Then, gear housing cover can be separated from gear housing. See Fig. 4.
4 pcs. of
Tapping screws CT 4 x 16
2.Take off stop ring E-3 with small flat head screwdriver. And push slider to the lower dead point. See Fig. 5.
Slider
Pin 4
Rod
3.Slide pin 4 in order to disconnect rod with slider. And then, pull out rod from gear housing cover.
Disassemble linear guides by unscrewing 4 ps. of pan head screws M4 x 10. So, leaf spring, pin 4 and slider can be
disassembled from gear housing cover. See Fig. 6.
Linear guides
Slider
Pin 4
Safety wire
4341T, 4341CT, 4341FCT
Stop ring E-3
Fig. 5
Gear housing
cover
Rod
Fig. 6
Gear housing cover
Fig. 4
Rod
Linear guides
Leaf spring
Slider in the lower
dead point
Slider
Pin 4
4 ps. of
Pan head
screws M4 x 10
P 4 / 14