Makita 4341CT Hardware Technical Information page 8

R
epair
< 9 >Disassembling parts in gear housing
1. After taking off safety wire from gear housing cover, unscrew 4 pcs. of tapping screws CT 4 x 16.
Separate gear housing cover from gear housing. See Fig. 18.
2. Locking crank complete with something bar-formed metal, unscrew 2 pcs. of hex socket head bolts M4 x 12 as
illustrated in Fig.19.
No.1R235
Round bar for arbor
Balance plate
Retaining ring S-8
3. Disassemble retaining S-8. Then, the inner parts can be disassembled from gear housing as illustrated in Fig.20.
4 pcs. of
Tapping screws CT 4 x 16
2 pcs. of hex socket
head bolts M4 x 12
Crank complete
Fig.19
Needle bearing 407
Retaining S-8
Balance plate
Gear complete
Push plate
Seal plate
Fig.20
Gear housing cover
Safety wire
4341T, 4341CT, 4341FCT
Fig. 18
< Note in disassembling>
2 pcs. of hex socket head bolts M4 x 12 are adhesive bolts.
It is recommended to unscrew them with impact driver.
Flat washer 8
Gear housing
P 8 / 14