Setting The Speaker Mode; Setting The Delay Time - Samsung HT-TX725 User Manual

System setup

SETTING THE SPEAKEr MODE

Signal outputs and frequency responses from the speakers will
automatically be adjusted according to your speaker configuration and
whether certain speakers are used or not.
1. In Stop mode, press the MENU button.
. Press the Cursor % button to move to Audio and then press the
ENTEr or + button.
.
In the SPEAKEr SETUP, press the ENTEr or + button again.
4. Press the Cursor $, %, _, + button to move to the desired speaker
and then press the ENTEr button.
For C, SL, and SR, each time the button is pressed, the mode
~
switches alternately as follows : SMALL  NONE.
~ For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.
~
NONE : Select this when no speaker is connected.
~
d Press the rETUrN button to return to the previous level.
d Press the EXIT button to exit the setup screen.
M
`
The speaker mode may vary, depending on PRO LOGIC and STEREO settings. (see page 56).

SETTING THE DELAY TIME

If the speakers cannot be placed at equal distances from the listening
position, you can adjust the delay time of the audio signals from the
centre and rear speakers.
1. In Stop mode, press the MENU button.
. Press the Cursor % button to move to Audio and then press the
ENTEr or + button.
. Press the Cursor % button to move to DELAY TIME and then press
the ENTEr or + button.
4. Press the ENTEr button.
. Press the Cursor _, + button to set the Delay time.
You can set the delay time for C between 00 and 05mSEC and
~
for SL and SR between 00 and 15mSEC.
d Press the rETUrN button to return to the previous level.
d Press the EXIT button to exit the setup screen.
0
MOVE ENTER RETURN EXIT
MOVE CHANGE RETURN EXIT