Advertisement
Quick Links
A
S
S
E
M
Touch
Tables for VESA Mounted Touch Screens and PCs.
Shown with optional EZ Cinch CPU holder, not inlcuded.
Modeled with LCD screens, CPUs, wireless keyboards and mice, not included.
iLid® Tables are available with laminate
tops and PVC edge trim (not shown) and
thrmofoil tops with contoured self edges
(shown).
Design of parts are subject to change.
B
L
Y
I
©2018 CBT Supply, Inc. All rights reserved. SMARTdesks® and
iLid® are registered trademarks of CBT Supply, Inc. Designs
are proprietary to CBT Supply, Inc. manufactured for each
customer with customization.
N
S
T
R
U
www.smartdesks.com
C
T
I
O
800 770 7042
N
S
Advertisement
Related Manuals for SMART desks iLid Touch
Summary of Contents for SMART desks iLid Touch
- Page 1 Touch Tables for VESA Mounted Touch Screens and PCs. Shown with optional EZ Cinch CPU holder, not inlcuded. Modeled with LCD screens, CPUs, wireless keyboards and mice, not included. iLid® Tables are available with laminate tops and PVC edge trim (not shown) and thrmofoil tops with contoured self edges (shown).
-
Page 2: Parts Identification
Parts Identification Available in thermofoil with contoured self edges or laminate with PVC edges. Legs: iLid® Tables are available in singles with two legs, doubles with three legs and triples with four legs. CPU Holders are options. They mount with a braket over the preferred leg, installing with the hex/phillips... - Page 3 Install iLid into table top There are two types of hinges that are mounted in pairs. Start by mounting the spring loaded hinge to the lid on the user’s left side. Each iLid mounts with a spring-loaded hinge and a passive friction hinge. The spring will keep the lid in the open position.
- Page 4 Install VESA bracket Use three Euro Screws to install the VESA mount to the iLid. The arangement of pilot holes give options for placement in 1/2” increments. The location can be fine tuned when installing the actual monitor. If desired, a “dry fit” for installing the monitor may be performed, so the location might be determined for the classroom.
- Page 5 Assemble legs and modesty panel NeatLinks wire man- agement channels are installed flush with the bottom of the mod- Fasten the legs using esty panel, centered Phillips/Hex drive 1/4-20 in the user workspace. bolts, six per mount- Do not rely only on ing plate.
- Page 6 Install Keyboard tray Keyboard Tray KB26 has four L brackets that need to be attached at a uniform depth with the tabs oriented inside. four metal machine screws are used to fasten the L brackets. This is shown using the third hole from the bend in the L. Install the KB26 keyboard tray using eight wood screws, two per L bracket.
-
Page 7: Finishing The Installation
Finishing the installation Put the table on the floor on its feet or casters. If you installed a CPU holder, such as the EZ Cinch or Brig, the bracket for this has been installed over the leg bracket. The CPU can be installed according to the directions that came with the CPU holder.
Need help?
Do you have a question about the iLid Touch and is the answer not in the manual?
Questions and answers