2-channel hdmi 2.0 splitter with analog and optical audio output supports 4kx2k uhd video (10 pages)
Summary of Contents for Hall Research Technologies UHBX-3S
Page 1
User’s Manual UHBX-6S UHBX-3S with Local HDMI output, RS232, & PoH HDMI on HDBaseT Splitter UHBX-3S 1 in x 3 out HDMI on HDBaseT Splitter Part Number Function UHBX-6S 1 in x 6 out HDMI on HDBaseT Splitter UMA1220 Rev D Order toll-free in the U.S.
HDMI on HDBaseT Splitter 1.0 Introduction The UHBX-3S and UHBX-6S are HDMI splitters with one local HDMI output and 3 or 6 HDBaseT outputs for transmission to compatible receivers up to 150 meters / 500 ft in Long Reach mode, or 100 meters / 328 ft in Standard mode using UTP cables (max distance is a function of receiver type and cable quality).
3.0 Setup Installation As shown in the diagram below, the UHBX-3S/6S can extend a single video source to multiple remote displays. There is also an additional HDMI output for connection to a local display or for daisy chaining to another Splitter. A maximum of (7) Splitters can be daisy-chained together.
UHBX-3S / -6S 4.0 Operation Make the connections as shown in the figure above and power up the UHBX-3/6S. If the UHBX-R-PD is used as the receiver, the PoH LED will illuminate after about 3 seconds to indicate that the receiver is also receiving power.
HDMI on HDBaseT Splitter EDID Management A main feature of the Splitters is EDID management. Two modes of operation are supported, Pass-Through or Emulate. The mode is selectable from the front panel of the splitter. In Pass-through mode, the EDID of the TV connected to the selected output passes to the video source.
UHBX-3S / -6S Serial Commands Connect serial interface to output (n). If n is not specified, then it reports which Command: XC,n<cr> stands for Serial Connect output the controller is connected. “n” is in the range of 1 to 99. Default is 1.
HDMI on HDBaseT Splitter 5.0 Troubleshooting If you are experiencing problems getting the extender to work properly, please use the following troubleshooting suggestions. Make sure that all of the connections on both the sender and the receiver are solid. • Try resetting the system by cycling power on the Splitter.
Threaded nuts on bottom for rack-shelf mounting or optional rack ears Enclosure type Metal Dimensions UHBX-3S: 1.66" x 8.42" x 5.59" (42mm x 214mm x 141mm ) (HxWxD) UHBX-6S: 1.66" x 11.23" x 6.59" (42mm x 285mm x 167mm ) Product weight UHBX-3S Product: 2.5 lbs (1.13kg), Shipping: 3 lbs (1.36 kg)