Advertisement
Twill Replace-a-top™ with Tinted Windows – Installation Instructions
Install Tailgate Bar on Vehicle
Insert the Tailgate Bar into the mounts on each side
of the tailgate opening with the vinyl side of the Rear
Window toward the outside of the vehicle.
Place Tailgate
Bar in mounts
Secure Rear Window Zippers
To start the zipper, pull the two sliders as far down
as possible on the driver's side of the window in
order to catch the sliders to the pin.
Once the zipper is caught, start the top slider
1/2". Then hold up the top of the window with one
hand and close the zipper with the other. The zip-
per is sandwiched between layers of fabric in the
corners so be careful not to catch extra fabric in
the zipper. Close the zipper.
Make sure that the Tailgate Bar is centered and is
securely in the mounts. Then tuck the fl aps on the
Rear Window under the top fabric.
Rev. C 0314
Window should be rolled up and secured with the
elastic garters for proper ventilation.
Remove the Quarter Panels and the Rear Win-
dow. To remove the Quarter Windows, release the
hook and loop and unzip the rear and top zippers.
Release the plastic strip from the retainer along the
bottom and front of the panel
To roll up the Rear Window, remove the Tailgate
Bar and open the zippers on each side of the
window to the top. Start at the bottom and roll the
window to the inside. Avoid wrinkles in the fabric
and window. Secure it in place with the elastic
garters inside of the top.
Tuck Flaps
under top
Start
Zipper
Pull both sliders down as far
as possible to catch pin
When operating the
vehicle without the Quar-
ter Windows, the Rear
To Fold the Top Down
Remove Quarter Windows and
Rear Window
79837 pg. 8
Advertisement
