Gear
Check that there is grease in the gear housing, and fill
with new grease if necessary. This should be done
approximately every 6 months. Do as follows:
1
Loosen the two screws (A) and (B), and remove the
cutting head from the shaft.
A
2
Check that there is grease in the gear housing by
looking in the hole for the drive shaft (se picture). If no
grease can be seen, the gear housing should be filled
with new grease.
3
Fill with grease by putting the tube of grease as far into
the hole as possible, and fill until grease starts to
trickle out of the hole.
4
Fit the cutting head on the shaft and tighten the two
screws.
MAINTENANCE
B
–
English
31