Husqvarna 135 Mark II Operator's Manual page 13

5. Continue to pull the starter rope handle until the
engine starts or tries to start (max. 3 pulls). If the
engine starts or tries to start, push the choke control
down.
CAUTION: Do not pull the starter rope
until it stops. Do not let go of the starter
rope when it is fully extended. Release
the starter rope slowly. Failure to obey
these instructions can cause damage to
the engine.
6. Continue to pull until the engine starts. Wait 60
seconds after a start before you pull the throttle
trigger.
7. Pull the front hand guard back towards the front
handle to disengage the chain brake.
8. Hold the rear handle with your right hand and the
front handle with your left hand.
9. Use the product.
To start a warm engine
1. Move the front hand guard forward to activate the
chain brake.
2. Pull the choke control out and up.
862 - 001 - 20.09.2018
3. Push the primer bulb 6 times.
4. Push the choke control down.
5. Hold the body of the product on the ground with your
left hand. Do not step on the product. Pull the starter
rope handle slowly until you feel some resistance.
Then pull the starter rope handle with force.
CAUTION: Do not pull the starter rope
until it has stopped. Do not let go of the
starter rope when it is fully extended.
Release the starter rope slowly. Obey
these instructions to prevent damage to
the engine.
Note: Do not pull the throttle trigger while you start
the engine.
6. Continue to pull the starter rope handle until the
engine starts or tries to start (max. 3 pulls). Wait 60
seconds after a start before you pull the throttle
trigger.
7. Pull the front hand guard rearward in the direction of
the front handle to disengage the chain brake.
8. Hold the rear handle with your right hand and the
front handle with your left hand.
9. Use the product.
13