POLA HP58 Handbook

INSTALLATION
How to connect the sensors
Connect the sensor provided as shown in the diagram.
For remote connections use a standard 0.5-square millimeter two-pole wire,
taking great care over the connections, by insulating and sealing the joins carefully.
-O.C.- is displayed when the temperature sensor wiring is open, -S.C.- is displayed
when the temperature sensor wiring is short circuit.
How to connect the line
Connect line on terminals L-N.
Protect supply with adequate fuse.
How to connect the contacts
Connect terminals on the terminal block (contacts up to 4AMP.AC1).
* Other power voltage if you required.
* 4-20mA humidity probe connection (with setting tEnP=3 in COSt).
Example with our
RHR humidity probe
As it company policy to continually improve the products the Manufacturers
reserve the right to make any modifications thereto without prior notice. They
cannot be held liable for any damage due to malfunction.
HP58
- +
9 10
R R=100 ohm resistor to be connected
in parallel by 9-10 terminals.
HP58
SL 4.0
0-10V Proportional
Handbook
MAIN SETTING (Run Mode)
TEMPERATURE SETTING
Press SET (key lamp flashes): this message will be displayed
instead of the ° Set temperature value .
Press + or - to modify, press SET to escape.
VIEWING TEMPERATURE RECORDING
Press + : will be displayed followed by
°Maximum Temperature Recording.
Press - : will be displayed followed by
°Minimum Temperature Recording.
Values are permanently stored in the memory: for deleting all values in the memory keep
pushed + key for more than 3 seconds: CLEA message will appear on display before
clearing operation.
STATE INDICATIONS LAMPS
BAR-GRAPH % 0-10V INSERT
Press TEMP key for at least 2 seconds to display % insert (PErC message will be
displayed instead of the infra-red lamps power % inserction).
Output Relay
HEAT ON
The lamps near set key indicates relay command status.
t.SEt = 25.0°
Example with
Output Relay
COOL ON