Advertisement
7. Clean out all the waste toner from the hopper. Be careful not to damage the recovery blade located next to the wiper blade.
8. Coat the new or cleaned wiper blade with your
preferred lubricant. Install the wiper blade and two screws.
© 2014 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
HP PRO MFP M125 SERIES CF283A TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
If this blade is bent in any way, the cartridge will leak.
Make sure the wiper blade foam seals are clean.
9. Install the cleaned PCR. Place a small amount of conductive
grease on to the black holder side of the shaft. Just a small
amount of grease is more than sufficient.
www.uninetimaging.com
Advertisement
