Sime Murelle EV HE 12 System User Instructions
Hide thumbs
Also See for Murelle EV HE 12 System:
- Installation and servicing instructions (48 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Sime Murelle EV HE 12 System
Summary of Contents for Sime Murelle EV HE 12 System
- Page 1 PLEASE LEAVE THIS INSTRUCTION WITH THE USER MURELLE EV HE User instructions...
- Page 2 All descriptions and illustrations provided in this manual have been carefully prepared but we reserve the right to make changes and improvements in our products that may affect the accuracy of the information contained in this manual.
- Page 4 The Benchmark Scheme Sime Ltd is a licensed member of the Benchmark Scheme which aims to improve the standards of installation and commissioning of domestic heating and hot water systems in the UK and to encourage regular servicing to optimi- se safety, efficiency and performance.
-
Page 5: Table Of Contents
DIGITAL RF TIME PROGRAMMER (CODE 8092232) ............13 Murelle EV HE 12 System: Gas Council number 41-283-12... -
Page 6: Operating Instructions For The User
(pos. 2) depends upon the potentiometer setting, to activate the winter mode functioning The Sime “MURELLE EV HE” family is a fully the rate at which water is drawn off, and (heating and D.H.W.). The display will be as... - Page 7 1.3.2 Regulation C.H. temperature (fig. 25) To set the temperature of the water for heating, press the key of the controls (2). The first time the key is pressed, the SET of heating circuit 1 is selected. The second time it is pressed, the SET if second zone fitted is selected.
-
Page 8: Errors And Solutions
ERRORS – ALL 06 (fig. 27/c) – ALL 13 (fig. 27/e) AND SOLUTIONS Press the key of the controls (2) to Press the key of the controls (2) to re-start the boiler. re-start the boiler. When there is a functioning error, the If the error persists seek help and advi- If the error persists seek help and advi- display shows an alarm and the blue lumi-... -
Page 9: Electrical Supply
recorded in the installation guide use and 1.8. 1 Cleaning fault exists on the appliance it MUST NOT maintenance section. be used until the fault has been rectified by Use only a damp cloth and mild detergent a competent person. to clean the appliance outer casing. -
Page 10: Mechanical Time Clock (Code 8092228)
MECHANICAL TIME CLOCK - Code 8092228 Setting the time The time of day can be set by grasping the outer edge of the black dial and turning it in a clockwise direction until the correct time is in line with the white pointer. -
Page 11: Digital Time Clock (Code 8092229)
DIGITAL TIME CLOCK - Code 8092229 When the selector is in the “AUTO” position, boiler func- When finished programming, set the selector to tioning is automatically controlled on the basis of the “RUN” position. temperature levels and time periods set. The second selector must be in the “RUN”... -
Page 12: Analogic Rf Time Programmer (Code 8092231)
ANALOGIC RF TIME PROGRAMMER - Code 8092231... -
Page 13: Digital Rf Time Programmer (Code 8092232)
DIGITAL RF TIME PROGRAMMER - Code 8092232... - Page 16 Sime Ltd 1a Blue Ridge Park Thunderhead Ridge Glasshoughton, Castleford, WF10 4UA Phone: 0845 9011114 Fax: 0845 9011115 www.sime.ltd.uk Email: enquiries@sime.ltd.uk...
Need help?
Do you have a question about the Murelle EV HE 12 System and is the answer not in the manual?
Questions and answers