Table of Contents
Advertisement
Using an existing bracket (continued)
Mounting the projector on an existing bracket
To combine this product with an existing ET-PKD120H, ET-PKD120S, ET-PKD310H, ET-PKD310S, ET-PKD56H,
ET-PKD55S, ET-PKD100H, ET-PKD100S, ET-PKD77H and ET-PKD75S, use the steps on pages 12 to 14 to install
this product and the drop prevention kit supplied with the product on the projector. Then install the projector on
the existing ceiling mount bracket according to the following instructions.
Note
z The illustration shows an installation using the ET-PKD56H ceiling bracket for high ceilings. Other ceiling
mount brackets for low or high ceilings can be installed according to the same procedure.
z The illustrations of projectors are for informational purposes only and do not represent a specific model.
Configurations may vary with the model.
Projector
mount bracket
Angle adjusting bracket
Hex head bolt, captive washer
16 - ENGLISH
ET-PKD130B_EN_TQZJ577-7.indd
16
Angle adjusting
bracket
Hex head bolt, captive washer
1) Align the screw holes on the angle adjusting
bracket with the holes on the projector mount
bracket and secure the bracket with the six captive
washer hex head bolts removed in the section
"Removing the projector from the existing bracket",
as shown in the figure on the left.
Attention
z After adjusting the installation angle, tighten the six
captive washer hex head bolts firmly.
For information on how to adjust the installation
angle, refer to the installation instructions or other
instructions supplied with the ceiling mount bracket
(for low or high ceilings).
Note
z The illustration of the angle adjusting bracket is for
informational purpose only and does not represent
a specific product. Tightening positions of the
captive washer hex head bolts may vary depending
on the shape of the angle adjusting bracket.
2017/03/13
19:05:05
Advertisement
Table of Contents
