Lens Position Setup And Focus Adjustment; Lens Position Setup (Using Projector Functions) - Panasonic ET-DLE030 Operating Instruction

Lens position setup and focus adjustment

Lens position setup (Using projector functions)

Automatically return the lens to base position using the projector.
* The menu screens shown in these operating instructions are only provided as examples. Actual menu screens
may vary with the specific model.
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
3D SETTINGS
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
SUB MENU
ENTER
PROJECTOR SETUP
STARTUP INPUT SELECT
RS-232C
STATUS
NO SIGNAL SHUT-OFF
REMOTE2 MODE
FUNCTION BUTTON
DATE AND TIME
LENS CALIBRATION
SAVE ALL USER DATA
LOAD ALL USER DATA
INITIALIZE
SERVICE PASSWORD
LENS
DLE030 POSITION
OK
ENTER
CANCEL
MENU
Note
z This method of adjustment does not work with the PT-DZ770, PT-DW740, PT-DX810, PT-DZ680, PT-DW640,
PT-DX610, PT-DW730, PT-DX800, PT-DZ6710, PT-DZ6700, PT-DW6300, PT-D6000 and PT-D5000. Use the
supplied lens shift gauge for adjustments.
z Lens position adjustments made from the projector may deviate slightly from adjustments made using the lens
shift gauge.
z After returning the lens to the standard projection position, lens shift adjustments are possible within the range
where the projector will not interfere with the edges of the projected image.
z If the rear of the projector blocks the bottom edge of the projected image, it may also obscure the view of an
On-screen display (OSD) that is positioned at the lower edge of the screen. If this happens, open the [DISPLAY
OPTIONS] menu and select [ON-SCREEN DISPLAY] → [OSD POSITION] to change display location so that
the whole OSD menu can be seen.
8-ENGLISH
2/2
LAST USED
SW1234567
ET-LAD120
DISABLE
DEFAULT
1.00
1.00
ACTIVATED
1) Turn on the projector to start the
projection.
2) Press the <MENU> button to open
the [MAIN MENU] screen. Then
select [PROJECTOR SETUP] and
press the <ENTER> button.
3) Select [SERVICE PASSWORD] in
the [PROJECTOR SETUP] menu
and press the <ENTER> button.
4) In the [SERVICE PASSWORD]
entry screen, press the numeric
button <0> and <3> on the remote
control to enter "030" and press
the <ENTER> button.
zThe [DLE030 POSITION] screen appears.
5) Press the <ENTER> button in the
[DLE030 POSITION] screen.
z[PROGRESS] is displayed on the [DLE030
POSITION] screen and lens position moves
to the standard projection position for the ET-
DLE030.