Yamaha EMX62M Service Manual page 16

EMX62M
3. MIX62 Circuit Board 2/2
(Time required: about 4 min)
3-1. Remove the front panel assembly. (See Procedure 1)
3-2. Pinch slightly the stopper of the power switch
escutcheon with a plyer, and pull it to the front to
remove. (Fig.6-1)
3-3. Remove the two (2) screws marked [90]. (Fig.6-2)
3-4. Remove the power switch knob marked [110]. The
MIX62 circuit board 2/2 can then be removed.
(Fig.6-2)
Pull Pull
4. Rear Panel Assembly
(Time required: about 5 min)
4-1. Remove the front panel assembly. (See Procedure 1)
4-2. Remove the six (6) screws marked [60] and the two
(2) screws marked [44]. (Fig.7)
4-3. Hold the cord holder and pull the rear panel to the
front to remove. (Fig.8)
Note: When reinstalling, install the rear panel
assembly and the front panel assembly in that
order to connect the power supply connector
easily.
[90] [100]
[44]: Bind Head Tapping Screw-B 4.0X8 MFZN2BL (EG340190)
[60]: Bind Head Screw 4.0X12 MFZN2BL (VB132700)
[90]: Bind Head Tapping Screw-B 3.0X12 MFZN2BL (VQ074600)
[100]: Bonding Head Tapping Screw-B 3.0X8 MFZN2BL (VN413300)
16
Push Push
MIX 2/2
Push Push
(Fig. 6-1)
[60]
[C]
[44] [100] [44]
(Fig. 7)
[110] [110]
(Fig. 6-2)
[90]: Bind Head Screw 3.0X8 MFZN2BL (VB659000)
[110]: Power Switch Knob MX12/4 (VU859000)
Body Assembly Body Assembly
(Fig. 8)
[90] [90]
Pull Up Pull Up
Rear Panel Assembly Rear Panel Assembly