Operational Safety Information - Rinnai Infinity 20 External Operation And Installation Manual

Do not store flammable objects near the appliance: it could cause a product
failure or fire.
Do not spray aerosols in the vicinity of this appliance while it is in operation.
Check that the appliance is supplied with the correct gas type and pressure
according to the data plate: ensure that the gas in use matches with the gas
indicated on the data plate. If not, there could be incomplete burning of the
gas, resulting in toxic emissions and/or product failure.
Do not insert objects into the flue outlet. Do not spray water directly into the
flue outlet. Keep, trees, shrubs, etc. well clear of the flue outlet.
On colder days steam may discharged from the flue outlet. This condition is
normal for high efficiency appliances and does not indicate a fault.
Check the main gas valve to make sure it is opened before using the
appliance and check the gas pressure is correct.
Metal flexible pipes are recommended for gas and water supply: rubber hose
might get damaged.
It is recommended to install valves on the gas and water pipes to allow an
easier maintenance and to increase safety in case of emergency.
Check the voltage at the power outlet to make sure it is within the appropriate
range before use.
Ensure the electrical system is provided with an appropriate grounding,
otherwise the appliance could be severely damaged or operate improperly
The extension of the power cord should be avoided (e.g. using an extension
cord or a multiple socket).
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Prior to use after installation or if the appliance has not been used for a long
time let the hot water flow for a while before using.
Do not touch the unit cover or the flue outlet.
It is recommended the installation of a system to collect and drain water
under the appliance in the case of water leakage to prevent material and
property damages.

1.2.1 OPERATIONAL SAFETY INFORMATION

The following instructions and warnings describe some of the important operational features of the water heater.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
IMPORTANT supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Always test the temperature of the water before bathing
or showering to avoid scalding and burn.
10
Data plate
Gas shut-off valve
Grounding
Whilst hot water outlets are open the set temperature
may be lowered. However they cannot then be raised
above 43°C. In addition transfer of 'priority' between
controllers is not possible. These are safety features.
Flexible pipes
Gas valve
Water valves
Hot Cold Gas
Grounding
HOT!