Toshiba USB001Z Instruction Manual page 3

■ General Operations
 Never disassemble, modify or repair.
This can result in electric shock, fire and injury. For repairs, call your sales agency.
Disassembly
prohibited
 Do not place or insert any kind of object into the unit(electrical wire cuttings, rods,
wires). This can result in electric shock or fire.

Do not allow water or any other fluid to come in contact with the unit. This can result in
Prohibited
electric shock or fire.

If the unit begins to emit smoke or an unusual odor, or unusual sounds, immediately
turn power off. If the equipment is continued to operate in such a state, the result will
be fire. Call your local sales agency for repairs.
Mandatory
■ Transportation & installation
 Don't place any inflammable objects nearby. If a flame is emitted due to malfunction,
it will result in a fire.

Don't install in any location where the unit could come into contact with water or other
Prohibited
fluids. This can result in electric shock or fire.
 Must be used in the environmental conditions prescribed in the instruction manual.
Use under any other conditions will result in malfunction.

Provide your inverter or other equipment with safety devices to prevent a serious
accident from resulting even if the unit malfunctions or fails to operate. Usage without
Mandatory
a safety device can result in an accident.
 Do not connect a LAN cable or modular cable for telephones to the conversion unit.
Doing so will cause a failure or accident.

Do not connect more than one conversion unit to one host device (computer). Doing
Prohibited
so will cause a failure or accident.
 Use the Toshiba-specified cable for connecting this optional unit. (Refer to page 5.)
The use of any other option will result in an accident.
 The following steps must be performed before wiring to an inverter.
Mandatory
(1) Turn off all input power to the inverter.
(2) Wait at least 15 minutes and check to make sure that the charge lamp of inverter
is no longer lit.
(3) Use a tester that can measure DC voltage 800VDC or more, and check to make
sure that the voltage to the DC main circuits (between PA/+ and PC/-) is 45V or less.
If these steps are not properly performed, the wiring will cause electric shock.
WARNING
WARNING
CAUTION
- 2 -
E6581299