Advertisement
Available languages
Available languages
1. Mounting
1.1 Mounting the holder
T1
Mount the holder in the following order from inside to
outside:
Nord-Lock washer (big) Holder Remove carton
Nord-Lock washer (small) Inbus screw cover
Note:
The ring carton is only used for transport protection
and has to be removed while mounting.
Additional mounting options are available under "Accessories" for
each device.
2. Commissioning
2.1 Removal of the service shaft cover
Loosen the captive screws of the service slot cover with a
Torx Tx10 screwdriver and remove the service shaft cover
subsequently from the device.
2
2.2 Connecting the cables
Connect all cables. Use the grommets in any case to
mount the cables properly and to ensure the IP protection.
Example of the cable installation
ATTENTION
Full IP protection is only guaranteed, if the
service shaft cover is installed properly!
2.3 Power supply connection
The device can be supplied by a 4-pin 24 VDC (optional
48 VDC) connection. Connect the device with a suitable
power supply.
PIN
SIGNAL
1
PE
2
0 VDC
3
Ignition
4
24 (48) VDC
2.4 Connection of all necessary utility lines
For the initial operation of the device a network connection
is required.
Note:
Entries can only be done by attaching an external
keyboard.
Note:
Additional information for using the ignition function
and the serial interface can be seen in the user
manual.
170608_DE_EN_DZ-HAND-93175-0/B
Quick Start Guide VMT6000 / VMT7000 / VMT8000 series
2.5 Switching on the device
ATTENTION
Danger of short circuits and damage to
the device in the event of condensation.
The device must be turned on, only after it
reaches room temperature.
2.6 Entering the Product Key
For devices with a pre-installed Windows operating system,
enter the product key when prompted. The license is located
on the rear side of the device.
2.7 Attaching the service slot cover
Install the previously removed service slot cover with the
captive screws at the device.
Note:
To ensure optimal and newest data and to be
informed quickly about technical changes, it is
recommended to use the contents of the website
www.ads-tec.de
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
V1.4
3. Safety instructions
ATTENTION
Any installation works on the device are
only permitted if the power supply is
switched off, and if handling the device is
safe
Note:
Please observe applicable security
measures when handling electronic
components sensitive to electrostatic
charges.
(DIN EN61340-5-1 / DIN EN
61340-5-2).
Note:
The configuration of software for your
device can be done by using the
"Configuration
Center",
which
is
preinstalled
and
can
be
found
in
"ads-tec Tools".
Advertisement
