Related Manuals for Grundfos CME-Plus
Summary of Contents for Grundfos CME-Plus
- Page 1 GRUNDFOS INSTRUCTIONS ™ CME-Plus Kit assembly Installation and operating instructions...
-
Page 3: Symbols Used In This Document
The use of this product requires experience with 3. General and knowledge of the product. The Grundfos CME-Plus® system is for the pumping of clean, thin Persons with reduced physical, sensory or mental and non-explosive liquids, not containing solid particles or fibers capabilities must not use this product, unless that may attack the pump mechanically or chemically. -
Page 4: Kit Assembly
See fig. 4. Tighten until or work area. wrench tight. If you purchased a completed CME-Plus from the factory, a discharge pipe and union is already installed in the pump discharge and the... -
Page 5: Install The Pump
– Thread the suction sized pipe nipple directly in the pump inlet fitting. – Thread the check valve onto the pipe nipple; tighten until wrench tight. If you purchased a complete CME-Plus from Note Note the factory, the pressure transducer and R100 settings are already installed. - Page 7 U.S.A. Canada México GRUNDFOS Pumps Corporation GRUNDFOS Canada Inc. Bombas GRUNDFOS de México S.A. de C.V. 17100 West 118th Terrace 2941 Brighton Road Boulevard TLC No. 15 Olathe, Kansas 66061 Oakville, Ontario Parque Industrial Stiva Phone: +1-913-227-3400 L6H 6C9 Aeropuerto...
- Page 8 Thinking ahead makes it possible Innovation is the essence L-CM-TL-004 0411 The name Grundfos, the Grundfos logo, and the payoff Be–Think–Innovate are registrated trademarks owned by Grundfos Management A/S or Grundfos A/S, Denmark. All rights reserved worldwide. © 2011 Grundfos Pumps Corp. www.grundfos.com...
Need help?
Do you have a question about the CME-Plus and is the answer not in the manual?
Questions and answers