Sharp DX-361HM Service Manual page 15

® REPLACEMENT OF PICKUP
When replacing the pickup, refer to "Cares when Handling
Pickup Assembly".
(a) After removing the CD PWB according to steps 1 - 4 of the
disassembling method, remove the lead wire and screw
in order of
CD
and
(2).
(b) Fit a new pickup in reverse order of disassembling.
(c) Connect the connector and lead wire as it was.
(d) The laser power adjustment is not necessary owing to
improvement of performance of pickup.
Note: When replacing the pickup do not apply force to the
turntable of spin motor. Otherwise, the height of main
chassis and turntable may be varied.
Figure 15-1
FITTING OF DISC HOLDER
1. Fit the disc tray into the disc holder.
2.
Lifting the disc tray, pass the guides through the grooves of
the disc holder and push the disc holder completely (when
passing the rear guides through the grooves, press the
switch lever).
-15-
Disc
Tray
Figure 15-2
Disc
Holder