Secure The Mr70; Security Screw; Verify Device Functionality And Test Network Coverage - Cisco Meraki MR70 Installation Manual

Secure the MR70

Depending on your mounting environment, you may want to secure the MR70 to its mount location. If the MR70 has
been installed using the mount cradle, it should be secured via security screw included with mount cradle.

Security Screw

Install the security screw in the lower mount cradle tab.

Verify Device Functionality and Test Network Coverage

1. Check LEDs
a. The Power LED should be solid green (or blue, if clients are connected). If it is flashing blue, the firmware is
automatically upgrading and the LED should turn green when the upgrade is completed (normally within a
few minutes). See the
b. Note: Your MR70 must have an active route to the Internet to check and upgrade its firmware.
2. Verify access point connectivity
a. Use any 802.11 client device to connect to the MR70 and verify proper connectivity using the client's web
browser.
3. Check network coverage
4. Confirm that you have good signal strength throughout your coverage area. You can use the signal strength meter
on a laptop, smart phone, or other wireless device.
IP67 Rating
The MR70 is IP67 rated if Dow Corning DC 4 (or equivalent) is applied as shown below:
"LED Indicators" section for more details. .
12