Adonis WX-2400 Instruction Manual

WIRELESS MOBILE MICROPHONE
Thank you very much for your purchase of "ADONIS" Wireless Mobile Microphone model WX-2400.
The model WX-2400 is non-directional high-performance mobile microphone with wireless method(between
microphone and control box) by weak radio wave, Integrated microphone and TX/RX Switch and Non-modulation
Prevention circuit with alarm.
Before using, please read this instruction carefully and use this microphone regularly for a long time.
★
Matters to be attended to
！Danger Never re-install or adjust the microphone during driving a car. Be sure to adjust the microphone before actual use.
！Danger Be sure to fix the cords and mount the microphone avoiding the possible trouble for safety driving.
！Warning Do not pull or wind the cords by force . It may cause a traffic accident.
！Warning The inside of this microphone is already adjusted and never modify or adjust the unit.
！Caution Do not make impact on the microphone. It may cause a trouble or damage.
！Caution This unit is not waterproof construction. Be sure to keep this unit dry.
！Caution Do not use this unit in the place of direct sunlight, high moisture and temperature, or poorly ventilated place.
！Caution Do not pull or insert the plug and jack under wet condition.
！Caution This unit is exclusively available with DC12V(±2V) power source.
！Caution This unit is not designed for emergency communication purpose. Please note.
★ ★
Warning and Note
·Do not use this unit nearby microwave oven or electronic products equipped with "blue-tooth". Please note there may be a
case not to use this unit depending on the environmental condition according to a radio wave, noise and mounting
surroundings.
·When finding any malfunction or damage on operation of this unit, stop your use and contact the dealer.
·Please note we are not responsible for the trouble caused by disassembly, modification and mistake on use.
·Do not use and put the unit in the place of full sunlight or high temperature.
·The design and specifications are subject to change without advance notice.
★ ★
PART NAMES (Please refer to the illustration.) (Fig. 1)
④ ③ ②
⑤
⑥
※MIC. CONVERSION CABLE IS NOT PROVIDED TO THIS UNIT.
★ HOW TO MOUNT AND CONNECT
·
④
Put the TX/RX CONTROL PART on flat space of steering wheel by using
accessory magic tape small
the place not to cause trouble for safety driving after cleaning the space to put on.
·
Insert the coin type Lithium Battery⑭ into
·
Put the ⑥ TX BATTERY CASE on flat space of the other(hidden) side of steering
wheel by using the accessory magic tape(small)
Magic Tape(small) should be cleaned before put. The
should be put on steering wheel closely and firmly so that the driver does not
have any trouble for safety driving.
！ WARNING
DO NOT MOUNT ON THE HORN SWITCH OR AIR-BAG.
IT IS VERY DANGEROUS.
·
Mount the ⑦ CONTROL BOX with accessory Magic Tape(large)
where you may watch the
·
Connect the Mic. Conversion cable suitable to the transceiver(Optional) between
⑪８Ｐ INTERCONNECT. JACK and transceiver.(Fig.1)
（ The Microphone Conversion Cable has a directional characteristics. Please
check it before connecting.）
WX-2400
MODEL
★
① ⑦ ⑧
⑪
MIC. CONVERSION CABLE
(ADONIS OPTION)
★
⑬ (Fig.2) The ⑬ Magic tape(small) should be put on
⑥ TX BATTRY CASE. (Fig.6a)
⑬.
⑨ TX Indicator Lamp ( LED).
⑨ ⑩ ⑫ ⑬
TRANSCEIVER
TO BATTERY
(Fig. 2) The place to put
⑤ CONNECTING CABLE
⑫ to the place
INSTRUCTION MANUAL
⑭ ①MICROPHONE
②TX BUTTON
③RX BUTTON
④TX/RX CONTROL PART
⑤CONNECTING CABLE
⑮ ⑥BATTERY CASE(TRANSMITTER)
⑦CONTROL BOX
⑧OUTPUT ADJUST. VOLUME
⑨TX INDICATOR LAMP（LED）
⑩POWER FEEDING LINE( RED)
⑪８Ｐ INTERCONNECT. JACK
（８Ｐ ADONIS ARRANGE）
ACCESSORY
⑫MAGIC TAPE LARGE（１ PC.）
⑬MAGIC TAPE SMALL (2 PCS.)
⑭LITHIUM BATTERY(COIN TYPE)
⑮POWER FEED. CONNECTOR
（Fig.2）Put ④TX/RX Control Part onto Handle
④TX/RX CONTROL ⑥Battery Case
⑬