Advertisement
CL1080
Temperature Controlled
SOLDERING INSTRUMENT
Burn Resistant
930
Soldering Station
includes CL1080 and IP329
WICK AND SOLDER SUPPLIES SOLD
SEPARATELY
IP329
Tool Base
TIP CARE
1. Plug-in Tool. Set to desired temperature. (Blinking lamp means
set temperature is reached.)
2. TIN the Tip (apply solder) before soldering.
3. Do not rub, bend or file Tip.
4. Always clean the Tip by wiping it against the saturated sponge,
then re-tin.
5. ALWAYS RE-TIN THE TIP BEFORE AND AFTER USING.
LONER
®
Temp. Regulation
Sponge Holder
• 120V, 60Hz, 70W, 5 Oz (142 gm)
• TEMP. RANGE: 400°F - 800°F (205°C - 427°C)
• TEMP. REGULATION: ±6°F (±3°C)
• TIP TO GROUND LEAKAGE: < 2MV
• TIP TO GROUND RESISTANCE: < 2 OHMS
• COMPLIES WITH DOD-STD-2000-1B, MIL-
STD-2000A and ESD SPEC. DOD-STD 1868,
DOD-HDBK-263
LISTED
Temp. Control
RS372
Retaining Sleeve
935
includes CL1080 , PD528 and PS536
PS536
Power Supply
made
in
U S A
Hollow Heater
Soldering Tip
Soldering Station
PD528 Tool Holder
not included with PS536
Power Switch
Sponge Holder
120 VAC
Receptacle
Advertisement
Table of Contents
Related Manuals for Edsyn CL1080 LONER
Summary of Contents for Edsyn CL1080 LONER
- Page 1 • 120V, 60Hz, 70W, 5 Oz (142 gm) • TEMP. RANGE: 400°F - 800°F (205°C - 427°C) • TEMP. REGULATION: ±6°F (±3°C) CL1080 • TIP TO GROUND LEAKAGE: < 2MV LONER • TIP TO GROUND RESISTANCE: < 2 OHMS ® •...
- Page 2 4. Insert new Tip. 5. Install RS372. (should be "finger" tight only.) SOLDERING TIPS Iron Plated for long life•Nickel and Chrome Plated for optimum heat transfer CONTACT EDSYN FOR MORE SELECTIONS .03 (0.8 mm) .48 (12.2 mm) LT374 Standard Probe .06 (1.5 mm) .48 (12.2 mm)
- Page 3 TEMPERATURE CALIBRATION AIR MOVEMENT WILL AFFECT THE TEMPERATURE READING. WORK IN AN AREA WHERE THIS IS MINIMUM. 1. Use the DS299S to remove the temperature control knob. Turn Temp. Control (A) so arrow points to cord. 2. Use the SRW01 to pull out heater assembly, PCB & power cord from handle. Leave enough power cord slack to install SRF30.
- Page 4 Knob, Temperature Control for Clear Handle SR111 Logo, Pointer, 3/8" Dia. Self Adhesive SR032 Cord Strain Relief SR033 Circuit Board, Model 930 15958 ARMINTA ST. VAN NUYS, CA 91406-1896 PHONE: 818.989.2324 FAX (sales): 818.997.0895 Email: info@edsyn.com Internet: www.edsyn.com © Copyright EDSYN,Inc.1998 FORM 380 Rev F...
Need help?
Do you have a question about the CL1080 LONER and is the answer not in the manual?
Questions and answers