Table of Contents
Advertisement
01616A DVD-V8000/TWN-Eng2
8/27/56 8:57 AM
Page 18
Tuner Band Setting
GB
This feature allows you to manually set the DVD-VCR's tuner band
to Antenna or Cable, whichever you connected to the Antenna In
jack during initial setup.
• Use this setting only if Auto Setup detected the incorrect tuner
band, i.e. channels are coming in on the wrong channel numbers.
1
1
2
3
4
18
Open "SETUP MENU"
Press the SETUP button.
Select "VCR & Channel Setup"
Using the up/down, move the selection arrow to "VCR & Channel
Setup," then push right to select.
Select "Channel Setup"
Move the selection arrow to "Channel Setup," then push right to
select.
Select "Tuner Band"
Move the selection arrow to "Tuner Band," then push right to select
from the following options:
• Auto - Automatically detects the Tuner Band.
• Antenna - Indicates that the DVD-VCR is connected to an indoor
or outdoor VHF/UHF antenna.
• Cable - Indicates that the DVD-VCR is connected to either
Community Antenna Television (i.e., cable TV without a cable
box).
Auto Channel Search
Auto Channel Search will automatically seek and store all active
channels in your area.
1
Open "SETUP MENU"
Press the SETUP button.
2
Select "VCR & Channel Setup"
Using the up/down, move the selection arrow to "VCR & Channel
Setup," then push right to select.
3
Select "Channel Setup"
Move the selection arrow to "Channel Setup," then push right to
select.
4
Run "Auto Channel Search"
Move the selection arrow to "Auto Channel Search," then push right
to select.
• The DVD-VCR will automatically search for all available
channels in the selected Tuner Band. This procedure may take
a few minutes to complete.
• When finished, the lowest channel found will be displayed.
GB
1
19
Advertisement
Table of Contents
