Connecting The Cables; Setting Up The Device Driver; Automatic Setup; Manual Setup - Samsung DVD-ROM drive User Manual

Connecting the Cables

1
Connecting the power cable
The 4-pin power cable from the internal power unit of your computer must be
connected to the power terminal on the rear of the DVD-ROM drive.
2
Installing a jumper on the master/slave select terminal
Install the jumper in the correct position on the terminal:
MA to use the device in the master mode
SL to use the device in the slave mode
CS to control the device via a CSEL host interface signal
See Step 3 for further details.
3
Connecting the IDE cable
Two configurations are possible.
The DVD-ROM drive is the only IDE device in addition to the hard disk.
Install the jumper in the SL position (Slave).
Connect the 40-pin flat IDE cable from the IDE port
IDE port
on the mother board, first to the DVD-ROM drive
Mother board
and then to the ha
DVD-ROM Hard disk
(SL) (MA)
You already have an additional IDE device installed in your computer.
First IDE cable
Second IDE cable
Install the jumper in the MA position (Master).
Connect the 40-pin flat IDE cable from a second
IDE port on the mother board directly to
Mother
the DVD-ROM drive or first to another additional
board
IDE drive and then to the DVD-ROM drive.
DVD-ROM CD-ROM
Hard disk
Hard disk
(MA) (SL)
(SL) (MA)
4
Connecting the audio cable from a sound card
Connect the 4-pin audio cable between the sound output terminal on the DVD-
ROM drive and the audio input terminal on the sound card.
1. Power cable
2. Master/slave select terminal
3. IDE cable
4. Audio cable
r d disk .
4

Setting Up the Device Driver

Automatic Setup

1
Insert the setup diskette in the diskette drive and change the directory to A:,
where A: is the diskette drive.
To do so, type A: after the C:\ prompt and press [Enter].
2
Type CDSETUP and press [Enter].
3
Reboot the computer.

Manual Setup

1
Make the C:\SAMSUNG directory.
2
Copy the files from the diskette to the C:\SAMSUNG directory.
* . *
To do so, type COPY A: C:\SAMSUNG after the C:\ prompt and press
[Enter].
3
Edit the CONFIG.SYS file.
Add the DEVICE=C:\SAMSUNG\SSCDROM.SYS \D:SSCD000 /V entry.
LAST DRIVE = Z
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
DEVICE = C :\SAMSUNG\SSCDROM.SYS /D : SSCD000 /V
4
Edit the AUTOEXEC.BAT file.
Add the C:\SAMSUNG\MSCDEX /D:SSCD000 entry.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
C :\SAMSUNG\MSCDEX /D:SSCD000
5
Reboot the computer.
5