Altronix PT2724 Installation Manual page 5

Depress ENTER until the flashing cursor appears under OFF (relay function) position in display.
Now select type of event required, by scrolling using the UP and DWN push buttons until either:
ON - Relay ON (latching mode), OFF - Relay OFF (latching mode), PL - Relay Pulse ( momentary)
appears in display. Depressing ENTER will make selection.
When selecting the pulse mode, PL01 will appear in the display. It is now necessary to assign the length
of time (duration of relay activation). The pulse can range in length from 1 second minimum to 15 seconds
maximum and is selected by using UP or DWN push buttons, then depressing ENTER to accept.
Note: If pulse duration is not selected, relay output defaults to 1 second.
Next, select individual day of the week and time (military) by scrolling using UP and DWN push buttons
and depress ENTER to accept. You may continue to program events by repeating the previous steps or exit
programming by depressing SET.
Note: When programming additional events, it is necessary to select the next consecutive event number
following the last event program to continue.
Note: When it is required to have the same event repeated on two (2) or more consecutive days of the
week (Block Programming), the event must be programmed as a block by selecting BK in the day field.
Note: To program the consecutive days of the week refer to Setting Block Event (weekly repeat) and
Daylight Savings Time - section C1 below.
2. Adding Events
Depress SET until
Depress ENTER
Depress ENTER. If the event is not programmed, the cursor will move to the OFF (relay function) position.
If the event is programmed, the cursor will move to the position and the programmed information of the event
will be displayed. At this point depress the UP button to step up through the programmed events. When an
unprogrammed event is reached, the cursor will move to the OFF (relay function position). At this point refer to
setting events or setting holiday events.
C. Setting Block Events (weekly repeat) and Daylight Savings Time:
Select channel A or B by moving slide switch SW3 to appropriate position.
Note: Channel cannot be changed in the middle of programming events. To change channelsyou must exit
programming then change channel switch position then enter program mode again.
Depress SET until
Depress ENTER.
1. Block Event Programming
Flashing cursor will appear at the location of the first day of the week desired. Depress UP and DWN
to select day. Depress ENTER to confirm selection, then cursor will appear at the location of the last
day of the week desired. Depress UP and DWN to select day. Depress ENTER to confirm selection.
1) Monday through Thursday depress MO followed by TH.
2) Wednesday through Sunday depress WE followed SU.
2. Daylight Savings Programming
The cursor will appear under DS (auto clock adjust daylight savings mode) in display. To change mode
depress UP or DWN once ST (clock does not adjust standard time mode) will appear in display.
Depress ENTER to accept correct selection.
Note: Select DS for areas that observe daylight savings or ST for areas that don't observe
daylight savings.
PT2724
A01 OFF
BK 00:00
ENTER to
SET EVENT
A01 OFF
SU 00:00
ENTER to
appears on display.
SET BK
A=SA/SU
will appear on display.
TIME=DS
appears on display.
appears on display.
- 5 -