Table of Contents
Advertisement
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC
outlet and the telephone line. It is recommended that a surge protector be installed to protect against such surges.
Master Volume Control
Page Time Out: Adjustable
from 5 to 60 seconds or
disable
Silence Time Out: Adjustable
from 2.5 to 10 seconds or
disable
Power LED: Red
Talk Battery
Switch
Talk
Switch
Battery
FXS
OFF
FXO
ON
A. Page Input Type
Use one of the following three diagrams (depending on the type of page input that will be used), to
connect the paging source. In all three cases, the 600 Ohm Audio Output can connect to a paging
amplifier. The Relay Contacts can be used to either switch in and out background music (See
Installation section B), or trigger the paging amp (See Installation section C).
1. FXS (Ring Trip) Mode (Not Using the Included Power Supply)
Select this mode if connecting to a FXS Port, or a Ringing PABX Extension. The FXI-1A will
answer a ringing line, activate its relay, and pass the paging audio onto the amplifier. It will then
drop the call based on Page Time Out, Silence Time Out, detecting a Busy Signal or Calling
Party Control (CPC). See Operation section A for further details.
For POT Settings,
See Programming
Section B
Red power LED
will be OFF
FXS
Talk Battery
Switch
2
Features Overview
Internal View of the FXI-1A
FXS
FXO
For use with
Ring Trip and
Page Port
Loop Start
Internal View of the FXI-1A
10
9
8
7
6
5
4
3
2
1
(2) #6 x 3/4" Panhead Screws (Included)
Power Input: 12VDC (included)
not needed in Ring Trip Mode
Installation
4
3
2
1
5
4
3
2
1
Active LED: Lights Blue when Paging
Night Bell
Background Music Input
Normally closed Relay Contact
Common Relay Contact
Normally Open Relay Contact
600 Ohm Audio Out
Audio In: FXS (Ring trip), FXO (Loop Start),
or VOX (Page Port) Input
ON
OFF
Enable Page Port Operation
Enable VOX Mode
VOX Sensitivity
Enable Busy Detect
Enable Pre-Page Alert Tone
See Installation Sections B and C
600 Ohm Audio Out to Paging Amplifier
FXS Port or Ringing PABX Extension
ON
OFF
Note: DIP Switch 4 and 5 must
See Programming section A.
be OFF.
Advertisement
Table of Contents
