Fire Hazard; Tool Operation - Reliable Equipment REL-BG Operator's Manual

WARNING

TOOL OPERATION

MANUAL CRIMPING TOOL
Read entire manual prior to using this tool.
(Refer to all safety recommendations and warnings)
Observe all safety precautions and procedures
required by the operating company.
Before crimping, ensure that crimp is within the
capacity listed for the tool.
Refer to connector manufacturer's instructions for
cable preparation and crimping procedures.
Ensure that you are using the proper die, as
recommended by the connector manufacturer.
Insert proper die into die seat.
Refer to appropriate DIE INSTALLATION on next page.
Place tool over connector.
Center connector between the dies.
Align jaw as necessary to ensure proper crimp.
Close handles until compression is complete.
Repeat as necessary to complete desired crimp.
IF YOU HAVE ANY QUESTIONS REGARDING THE PROPER USE
AND/OR OPERATION OF THIS TOOL, CONSULT YOUR AREA SUPERVISOR,
OR CONTACT RELIABLE EQUIPMENT AT
An incomplete crimp may pose a fire hazard.
Always use the appropriate connector, die set, and compression
tool, as required by the intended application.
Compression tool should be tested on a regular schedule to
ensure acurate compression.
Failure to observe this warning could result in serious injury.

FIRE HAZARD

FIRE HAZARD FIRE HAZARD
FIRE HAZARD FIRE HAZARD
9
Fixed O ro BG Die
Die Seat
Forged Steel Jaws
Do not operate
without dies.
Bent
Fiberglass
Handle
Anti-slip Grip
800-966-3530