The KH-20 is a pre-wired pickguard assembly that has been used by Kirk Hammett (Metallica) since 1987. It has 2 EMG-SA Single Coil Pickups
and the EMG-81 Pickup in the bridge position. The System features a Single Master Volume and Tone Control (Passive) and a 3 position selection
switch. The SA Pickups have Alnico Bar magnets for High Output and great sustain. The 81 Pickup features a Ceramic and Steel construction
with dual steel bars for high output, linear tone and amazing sustain.
0.025
LOG FREQ (kHz)
SPECIFICATIONS:
Logo Color
Magnet Type*
Resonant Frequency (KHz)
Output Voltage (String)
Output Voltage (Strum)
Output Noise (60 Hz)
Output Impedance (Ohm/System)
Current @9V (Microamps/Complete System)
Battery Life (Hours)
Supply (Volts DC)
* Magnet Type: A (Alnico) C/S (Ceramic/Steel)
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
Page 1
Warranty All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This warranty covers only those pickups and accessories sold by authorized EMG Dealers.
Page 2
2) Unscrew the existing Output Jack Plate (2 screws) and either unsolder or cut the 2 wires going to the existing output jack. 3) Remove the existing Output Jack and install the 12B Stereo Jack included with the KH-20 System.