Kubota WG1605-E3 Diagnostic Manual page 51

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, DM
(Continued)
States (CL Test State)
1) Inactive
2) Pre-cat init test
3) Pre-cat heater test
4) Pre-cat power test
5) Pre-cat voltage test
6) Pre-cat BM test
7) Post-cat heater test
8) Post-cat power test
9) Post-cat rich test
10) Post-cat lean test
11) Finished
12) Invalid
Pre-Catalyst Monitored Status (CL Pre-Cat Test
Status)
1) Test Not Started
2) Test Running
3) Test Finished: Passed
4) Pre-cat EGO Lazy (generates appropriate EGO
Lazy fault)
5) Pre-cat EGO Power Low
6) Pre-cat EGO non-responsive
7) Pre-cat EGO fueling error
8) Cannot start test (FPP or TCP % above limit is
detected)
Post-Catalyst Monitored Status (CL Post-Cat Test
Status)
1) Test Not Started
2) Test Running
3) Test Finished: Passed
4) Post-cat EGO Lazy (generates appropriate EGO
Lazy fault)
5) Post-cat EGO Power Low
6) Post-cat EGO Rich Failure
7) Post-cat EGO Lean Failure
8) Cannot start test (FPP or TCP % above limit is
detected)
1-41
ECM SYSTEM
KiSC issued 12, 2016 A