Polaris DP-20 User Manual page 52

4. Use the ARROW keys to scroll until TEST
5. Press the ENTER key to enter the TEST
6. Use the ARROW keys to scroll until GUIDE
8. Use the SENSOR key to change the mode, if
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
SIGNALS is displayed on line 3.
SIGNALS menu. SENSOR CURRENT will be
displayed on line 3.
TEST MODE is displayed on line 3.
7. Press the ENTER key to enter the GUIDE
TEST MODE menu.
displayed on line 2 which indicates that the
oscillator is running. The currently selected
oscillation mode will be displayed on Line 3.
desired. After a mode change, the mode
designation on line 3 will flash for 20 seconds.
If mode 1 is selected, the guide oscillates back
and forth within 80% of the bandwidth of the
currently selected
instantaneous 80% Guide Point Shifts.
mode 2 is selected, the guide oscillates back
and forth within 80% of the bandwidth of the
currently selected sensor, simulating 4% steps
in Guide Point Shift. If mode 3 is selected, the
guide oscillates, switching back and forth
between the Guide Point of the left edge sensor
and the Guide Point of the right edge sensor
(with 0% Guide Point Shift in both sensors).
This requires the sensors to be placed at a
spacing wider than the width of the web. The
sensor spacing determines the amplitude of the
oscillation.
DP-20 WEB GUIDE CONTROLLER
RUNNING will be
sensor, simulating
If
6
6-30
× 3A.3.8
SETUP (MAN)
TEST SIGNALS
× 3A.3.8.1
SETUP (MAN)
SENSOR CURRENT
× 3A.3.8.3
SETUP (MAN)
GUIDE TEST MODE
× 3A.3.8.3.1
RUNNING
× MODE1 1
-ÜÜÜÜÜÜÜÜ+ 0.50s
× 3A.3.8.3.1
RUNNING
× MODE1 10
-ÜÜÜÜÜÜÜÜ+ 0.01s
× 3A.3.8.3.2
RUNNING
× MODE2 1
-ÜÜÜÜÜÜÜÜ+ 0.01s
× 3A.3.8.3.3
RUNNING
× MODE3 10
-ÜÜÜÜÜÜÜÜ+ 0.01s
Figure Sheet 1-862-D