Polaris DP-20 User Manual page 28

2. Press the ENTER key to enter the BASIC
3. Use
4. Press
5. If necessary, use the ARROW keys to select
6. Press the ENTER key to begin the calibration.
7. Press the ENTER key. WAIT... will be displayed
8. Once the delay has ended, COVER SENSOR
9. Press the ENTER key. If the contrast is
06-05-2007
DP-20 WEB GUIDE CONTROLLER USER MANUAL
Menus. The GAIN menu will be displayed.
the ARROW
CALIBRATION is displayed on line 3.
the ENTER
CALIBRATION menu. SELECT SENSOR will
be displayed on line 3.
the Edge of Line sensor input.
displayed on line 1.
UNCOVER SENSOR will be displayed on line
2. With the sensor light spot correctly focused
on the material to be guided, position the
sensor such that the light spot is located on the
background, near the line to be guided, but not
on the line (see graphic at right). The sensor
signal is displayed on Line 3.
for a few seconds on line 4 of the LCD Panel.
Maintain the web position during this wait
period.
will be displayed on line 2. Position the sensor
such that the light spot is located fully on the
line to be guided (see graphic at right). The
sensor signal is displayed on Line 3 of the LCD
Panel.
sufficient for guiding, SUCCESSFUL will be
displayed for a few seconds on line 2, then the
unit will automatically exit the menus and return
to the Operator Level.
—
OR
DP-20 WEB GUIDE CONTROLLER
keys to scroll until
key to enter the
will be
Ł
—
6
6-6
Ł 3E.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
Ł 3E.1.4
SETUP (MAN)
CALIBRATION
Ł 3E.1.4.1
SETUP (MAN)
SELECT SENSOR
(X4)
Ł 3E.1.4.1
SETUP (MAN)
SELECT SENSOR
(X4)
Ł 3E.1.4.2
UNCOVER SENSOR
-ÜÜÜÜÜÜÜÜÜÜ+ 0%
Light Spot
Line
Ł 3E.1.4.2
UNCOVER SENSOR
-ÜÜÜÜÜÜÜÜÜÜ+ 0%
WAIT...
Ł 3E.1.4.3
COVER SENSOR
-ãããããããããá+ 95%
Light Spot
Line
Ł 3E.1.4.4
SUCCESSFUL
-ãããããããããá+ 95%
3E
MANUAL
Ł -ãããããáÜÜÜÜ+
Figure Sheet 1-862-D