System Requirements; About The Software - Samsung I100 User Manual

System requirements

For Windows
PC with processor better than
Pentium 450MHz
(Pentium 800MHz recommended)
* Samsung Converter
PC with processor better than
Pentium III 500MHz (Pentium IV
recommended)
Windows 98SE / 2000 / ME /
XP/Vista
* Samsung Converter
Windows 2000 or later
recommended
Minimum 128MB RAM
(Over 512MB recommended)
USB port
CD-ROM drive
1024×768 pixels, 16-bit colour
display compatible monitor
(24-bit colour display
recommended)
Microsoft Direct X 9.0 or later
118
For Macintosh
Power Mac G3 or later, or Intel
Processor
Mac OS 10.1 - 10.4
Minimum 256MB RAM
110MB of available hard-disk space
USB port
CD-ROM drive
MPlayer (For movie clip)

About the software

After inserting the CD-ROM provided with this camera into the
CD-ROM drive, the following window should automatically display.
Camera driver: This enables images to transfer between the
camera and PC.
This camera uses the USB Storage Driver as the camera driver. You
can use the camera as a USB card reader. After installing the driver
and connecting this camera to the PC, you can fi nd [Removable Disk]
in [Windows Explorer] or [My computer]. A USB Storage Driver is
provided only for Windows. A USB Driver for MAC is not included with the
Application CD. You can use the camera with Mac OS 10.1-10.4.
XviD codec: This makes movie clips (MPEG-4) recorded with
this camera play back on a PC.
To play back a movie clip recorded with this camera, you must install the
XviD codec. If a movie clip recorded with this camera does not play well,
install this codec. This software is only compatible with Windows.
Before connecting the camera to the PC, you
should fi rst install the camera driver.