Danfoss TP7000-RF Installation Instructions & User Manual page 5

7-day - each day can be programmed with diff erent times and
temperatures.
5/2 day - one set of times & temperatures for weekdays, and another
set for weekends.
Optimum start control - function which switches the heating on
earlier than the Event 1 programmed time to ensure the required
temperature is achieved by the set time.
Chrono-proportional control - energy saving feature which fi res the
boiler at regular intervals to maintain a set temperature, achieving a
constant ambient environment for the user.
Setting Optimum Start Control
Set Sw2 to OSC ON
(see DIL settings page 4)
Select OPTIMISER CURVE in
programming mode
A Event 1 Set Point
B Deviation from Set Point
C Switch On Time prior to Event
D Optimiser Curve Setting
TP7000 Wiring (not RF models)
2
1
COM
ON
M 24V models only
B C
24V
2
Note: 1.0mm solid copper cable should be used to connect the remote
sensor to the TP7000A. Please ensure that:
a) the cable length does not exceed 50 metres,
b) to avoid electrical interference the cable should not be run parallel
in close proximity to other cables carrying mains electricity, and where
necessary the cable should cross over mains cabling at right angles.
ELECTRONICS
3 4 5
OFF
M 230V models onl
L N
230V
A
-1˚C
B -2˚C
-3˚C
-4˚C
120 90
min. min.
6 7
REMOTE
SENSOR
'A' models
only
GB
D
60 30 Event
min.
min. time (
C
5