Advertisement
NO PART OF THIS DOCUMENT MAY BE REPRODUCED WITHOUT PRIOR AGREEMENT AND WRITTEN PERMISSION OF
STEP 4:
Use a screwdriver to lift retaining clip on clamp at rear of the Y-pipe and slide back (See Fig. 1).
STEP 5:
Remove pipe from muffler (cut pipe in front of the rear axle if ground clearance is an issue).
STEP 6:
To remove muffler, spray penetrating oil on front inner hanger and pry rubber hanger free from the hook.
Slide the muffler toward the front of vehicle to remove from the other hangers.
STEP 7:
Place X-pipe on the Y-pipe assembly to determine cut location (See Fig. 2). Be sure to center the new X-
pipe as best as possible to the center of the vehicle (See Fig. 3). Mark the end of the tube with tape (See
Fig. 4). Measure back 1½ inches (40 mm) from the tape and mark the cut line with tape (See Fig. 5 & 6).
Factory Ford shop manuals are available from Helm Publications, 1-800-782-4356
Techline 1-800-367-3788
M-5230-V6
Mustang V6 Dual Exhaust Kit
INSTALLATION INSTRUCTIONS
FORD RACING PERFORMANCE PARTS.
Fig. 2
Fig. 5
Page 2 of 5
Fig. 1
Fig. 3
Fig. 6
Fig. 4
IS-1850-0277
Advertisement
