OPCOM Farm GrowWall2 Quick Manual Manual

GrowWall2
Thank you for purchasing OPCOM Farm GrowWall2, the indoor hydroponics growing system. It is designed
with easy to use and efficient growth by one-touch AUTO mode. It holds up to 80 plants capacity. Read the
quick guide carefully before setting it up. For detailed user guide video, please scan the QR code or visit
GrowWall2 page at http://www.opcomfarm.com/Growwall2
A. Assembly
A1. Remove all the parts from box and check all the accessories
LED
L5
LED Growth Tube
L5
LED
L32Tx1
L4
L4
L15Tx8
LED
Grow Kits
L3
1. Seedling Kit:
L3
LED
L2
2. Nourishment:
L2
L1
Planting Kit
L1
AC
1. Small Filter Bag x30pcs
PUMP
2. Large Filter Bag x30pcs
A2. Assemble GrowWall2 main body.
1. Assembly
Follow the number of corresponding layers to the picture above, from
1
bottom to top. Insert the base stands (both sides) onto L1 and lock it. Stack
L2 on top of L1 and secure with quick locks on both side. Repeat the same
step until L5 is locked and in place.
Install 2 Anchor Bolt with Wall Mount Brackets on the both side of
2
L5 and place 2 Light Bar Holder on the Anchor Bolt.Insert two ends
of light bar(L32T) to the L shaped light bar holders. Make sure power cable
of the light bar is on the right.
2. Water Line setup
Link water hose from L5 water tray to water pump then tie it up on
3
both ends with hose clamps.
3. Electric Line setup
Attach the control box with clip buckles.
4
Connect all the LED, control box, and water motor cables according
5
to the marks on every splitter box. Organize all the lines, cables and
splitter boxes inside the C cuff per layer.
4. Other Installations
Lean and tilt the fully assembled product against the wall. Keep the
6
base stands 8.2 inch(21cm) away from the wall. Use the levelers on
the bottom of each base stands to even out the whole unit. Please
find the bubble level tool on L1 water tray for this task.
Add 10.5 gallons (80% full) water to the water tank.
7
Water flow is adjustable per water requirements of the plants. Rotate
8
the valvetap in the pump cloclwisely to increase water flow and
counter-clockwise to decrease water flow.
Please use included insect net to create better growing environment
9
and cleaner produce.
Chart I: Control Box Mode
Fuction Status Light Time(On/Off) Fuction
Auto 16H/8H
ON 24H/0H
LED High 18H/6H Pump
Low 10H/14H
OFF 0H/24H
Most plants can be grown using the AUTO mode.
*
* You can reset the product timeline by pushing the LED button for 2 sec.
.
Base Light Bar AC
Stand x 2 Holder x 2 Hose x 1 Cable x 1
Planting Partition x 10
Seedling tray(ST-70) x2pcs Grow Sponge 2x60pk Grow Sponge 2x60pk
(521*189*82mm) (OASS01K For Green Lettuce) (OASS02K For Red Leaf Lettuce)
NT-Starter x3pcs NT-Adjuster x15pcs 3. pH adjusters: pH + x15pcs
(OAMS26K for 40L) (OAMS29K for 40L)
Accessories Manual
1. EC & pH 2. Anti-insect 3. Waterproof Warranty Card
Meter x1pcs net x1pcs tape x1pcs
2
A2
L32T
4 L5
L4
1
L3
L2
L1
9
8
7
Anti -Insect Net
Status Light Time(On/Off)
( 10 mins/cycle )
Auto 48 cycles/day
48 cycles/day
ON ( 15 mins/cycle )
1 0 .5 gallon(40L)
High 4 cycles/day ( 10 mins/cycle )
Low 2 cycle/day ( 10 mins/cycle )
OFF 0 cycle/day
☑
Please read and follow every steps to avoid any malfunction.
B. Seedling
B1. Sprout stage
1. Add water into the seedling tray, up to the water (red) line.(Fig1)
2. Open Grow Sponge package, put the sponge into water of seedling tray(make sure the front side with
the seed label is up), press the sponge into water 5 seconds and let the sponge absorb water completely.(Fig1)
3. Place the seedling tray with cover in the shade or cover it with black cloth(to block light).(Fig2)
4. Spray water to Sponges and keep them wet everyday.(Fig3)
5.During 7 days(leaf plant), find the sprouted one in the tray; pick it out, and move it into product (make
sure the sponges line up with the black dot on the partition) and to next stage: B2. Young Plant Stage.
6. Discard unsprouted sponge after regular germination time.
* Different plant may have different germination time, please check it before plant.
Chart II: Plant Stage
Wall Mount
Brackets x 2
Basil, Lemon Balm
Sprout Stage
Young plant stage
Anchor
Bolt x 2 Growing Stage
* Please keep the seedling sponge package in refrigerator if you don't use it.
* For your expected plant amout, you can refer to the sprout rate of 1st planting cycle.
Grow Sponge 2x60pk
(OASS06K For Basil)
pH - x15pcs
Status
NT-Adjuster
Quick Guide Manual
Quick Guide Manual
Satus
pH+
pH-
B3. Growing Stage
4 3 1. When plants grow to 3-4 inches height, switch control box to auto mode. Please refer to Chart II.
2. After 4-6 weeks, harvest the larger plants for consumption and keep smaller plants growing.
3. For time saving, sow the new seeds in sprout tray one week before you start next planting process.
C. Planting
5 LED PUMP
System AC C1.Planting Process: Buy plants from local stores
L4 L1
L4 L1
Choose a suitable filter bag size for 2", 3", 4" pot, put it into the
1
filter bag and tie the strings(Fig1), For 5", 6" pot, remove the pot
and put it into 4" filter bag, tie the strings and put into tranfer
pot(optional)(Fig2) ; Then put the plants into tank(Fig3)
3
2" 3"
(Fig1)
PUMP
2"x 8pcs
1Line
Wall Mount Brackets
Soil F Soil Free: Remove pot(Fig1) and put into filter bag(Fig2) and then move
2
to the product(Fig3).
6
Adhesive for flat surface
(recommend).
6
(Fig1) (Fig2)
Combination: You can mix different size of pots and sponges
3
Screws for solid installation
in the growing hole of GrowWall2.
(Remove R5 / L5 before
using screws).
T (℃)
Planting Time LED Mode Pump Mode Nourishment
Day 0~7 N/A N/A N/A 20℃- 25℃
Day 3~14 ON ON NT-Starter 15℃- 30℃
After Day 14 Auto Auto NT-Adjuster 15℃- 30℃
* If you need more planting information, please vist to www.opcomfarm.com to read "Plant Q&A".
0.0-0.5 0.5-1.0 1.0-1.5
(Add 2pcs) (Add 1pcs) Standard range
4.0-4.5 4.5-5.0 5.0-5.5 5.5-6.5 6.5-7.0
(Add 3pcs) (Add 2pcs) (Add 1pcs) Standard range
Standard range 1pcs
C2. Flower Selection
Rainbow Tree
4"
(Fig2) (Fig3)
5" 6"
White Bunny Ears
3"x 5pcs 4"x 4pcs
1Line 1Line
2" Pots x 16pcs
(Fig2) (Fig3)
Free combination
This side up!
(Fig1)
(Fig2)
(Fig3)
RH EC pH Notes
80% 0.5-1.0 5.5-6.5 The sponge is fully wetin seedling tray.
45%-70% 1.0-2.0 5.5-6.5
45%-70% 1.0-2.0 5.5-6.5
Plant Size Small
Sponge Number 120
Planting number 80 (70%)
How to Set up x 3 Layer
over 2.0
Add water
Plant Size Medium-Large
Sponge Number 60
Planting number
40 (70%)
7.0-7.5
How to Set up x 3 Layer
2pcs
1 week
Harvest
4-6 weeks
Keep
Cut off Large leaf for regrow
Formaldehyde Clean
Chlorophytum Lucky Bamboo Chrysanthemum Snake Plant
Trichloroethylene Clean
Golden barrel Mottled Spurge Turk's Cap Cactus Golden ball cactus
Carbon dioxide & Formaldehyde Clean
Dot plant Wax Plant Dragon tree Barberton daisy Dragon tree
Xylene Clean
Dumbcane Tuberous Sword Fern Flaming lily Evergreen Pteris cretica
Carbon Monoxide Clean
Ivy Peace Lilies Parlour Palm Aloe Spiral-leaved croton