Connecting A Vcr - Samsung TX P1634 Owner's Instructions Manual

I
N S TA L L AT I O N

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable
TV system (according to the instructions on pages 11-14). Skip step 1 if you have not yet
connected to an antenna or a cable system.
1
Unplug the cable or
antenna from the back of
the TV.
2
Connect the cable or
antenna to the
ANTENNA IN terminal on
the back of the VCR.
3
Connect a coaxial cable
between the ANTENNA
OUT terminal on the VCR
and the antenna
terminal on the TV.
A coaxial cable is usually included with a VCR. (If not, check your local electronics
store).
4
Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the AUDIO jacks
on the TV.
5
Connect a video cable
between the VIDEO OUT
jack on the VCR and the
VIDEO jack on the TV.
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
Note: This figure shows the Standard connector-jack panel. The actual configuration for your
TV may be different.
VCR Rear Panel
Incoming
Cable or
Antenna
VCR Rear Panel
VCR Rear Panel
VCR Rear Panel
TV Rear Panel
Coaxial Cable
TV Rear Panel
Audio Cable
TV Rear Panel
Video Cable
15