Table of Contents
Advertisement
O
P E R AT I O N
Memorizing the Channels
Your TV can memorize and store all of the available channels for both "off-air" (antenna)
and cable channels. After the available channels are memorized, use the CH ▲ and
CH ▼ buttons to scan through the channels. This eliminates the need to change channels
by entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press MENU to
display the menu.
2
Press CH ▼ two times to
highlight "SET UP."
3
Press VOL +.
The setup sub-menu will
appear. Press CH ▼ to
highlight ANT/CATV.
4
Repeatedly press VOL + to cycle
through these choices:
ANT (antenna), STD, HRC or IRC (all
cable TV).
Note: STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
At this point the signal source has been selected. Proceed to "Storing
Channels in Memory" (next page).
SET UP
Channel set up
ANT / CATV
ANT
Time
Convergence
Language
English
Caption
V-chip
±
Move
Ent.
Exit
SET UP
Channel set up
ANT / CATV
ANT
Time
Convergence
Language
English
Caption
V-chip
±
Move
Sel.
Menu
Channel set up
ANT / CATV
Time
Convergence
Language
Caption
V-chip
±
Move
Sel.
SET UP
STD
English
Menu
C
HAPTER
3.5
T
: TV O
HREE
PERATION
Advertisement
Table of Contents
