Beck com.tom M-Bus 4.1 Startup Manual

M-Bus 4.1 – Start-up Guide
com.tom
The com.tom M-Bus devices communicate with
the web portal via Ethernet and the existing
network infrastructure. The communication
mechanism has a low data volume and can be
integrated easily in the existing network infra-
structure.
Device may only be put into service and
operated by qualified personnel. The device
is designed for an installation on a grounded 35
mm DIN rail in dry rooms.
After the installation the housing of the device is connected with
functional earth.
The power supply must be a grounded circuit (PELV). The power
supply must be a limited power source according to EN60950-1
Cap. 2.5 or the device must be provided with an anti-surge fuse of
2A. The digital I/Os are provided with a detached anti-surge fuse of
4A.
Pin Assignment
Power Supply
FE Functional earth
GND Ground
VCC 24 VDC
Digital I/Os
+ 24 VDC
S01,S02 Digital pulse input, source
Out1, Out2 Digital output, source
MB+, MB- M-Bus
- Ground
Serial Interface
RS232
Pin 1 NC
Pin 2 RxD
Pin 3 TxD
Pin 4 NC
Pin 5 GND
Pin 6 NC
Pin 7 RTS
Pin 8 CTS
Pin 9 NC
Housing Connected to functional earth
RS485 RS422
A(-/Y) A(TxD)
NC NC
NC NC
NC A'(RxD)
GND GND
B(+/Z) B(TxD)
NC NC
NC NC
NC B'(RxD)
CAN Interface
Pin 1 NC
Pin 2 CAN_L
Pin 3 CAN_GND
Pin 4 NC
Pin 5 CAN_SHLD (optional)
Pin 6 CAN_GND
Pin 7 CAN_H
Pin 8 NC
Pin 9 NC
Housing Connected to functional earth
Ethernet Interface
Green LED Link indication
Yellow LED Activity indication
LEDs
Status A Communication with Portal successful
Status B Diagram loaded (on) / executed (flashing)
Status C Freely programmable
Status D Freely programmable
Power Device is powered
Other Interfaces
SD card interface MMC/SD card
SIM card interface no function
Getting Started
Wire the com.tom device according to the technical data.
Afterwards get the Getting Started documentation WEB-PLC
at www.beck-ipc.com/gettingstarted and follow the steps
described there to put your com.tom device into operation.
General Data
Size (W x L x H) 46 x 105 x 70 mm
Operating temperature 0 bis 55 °C
Electrical shock Class III
Protection rating IP20
EMC emission IEC 61000-6-4
EMC immunity IEC 61000-6-2
Compliance CE, RoHS
Electrical Data
Supply voltage
24 VDC (15 %)
Active current < 0.08 A (without I/Os)
≤ 0.5 A / output
Scope of supply
1 Piece com.tom M-Bus 4.1
1 Piece Start-up guide
1 Piece Connector 3-pin
1 Piece Connector 10-pin
Copyright © 2013 Beck IPC GmbH
www.beck-ipc.com