D-Link DLM-3500 Quick Installation Manual page 6

2.3 DLM-3500 Web-based UI Overview
After logged in, you will be able to start configuring or monitoring DLM-3500 through the Web-based UI.
In order to help you to familiar with the basic operations, the explanations are as follows:
The Web-based UI tasks are grouped into four categories. The categories are located at the upper left-hand
corner of Web-based UI task bar. The four categories are:
System
Network
Service
Log
On the first stage,you can login as Administrator in the Web-based UI and modify the Administrator or
Monitor password by performing the following:(1)Click System and select Administration on task bar,(2)
enter your new admin password or monitor password, after the system confirmation, using the new
password next time you log in.
Password Recovery
If you forget your administrator password, use a Terminal (VT-100 compatible) to establish the connection
between PC RS-232 series port and DLM-3500 Console interface, execute system reset to default.
Before you log into serial console, please complete following setting: Bits per second: 9600, Data bits: 8,
Parity: None, Stop bits: 8, Flow control: None. The serial console and Web-based UI use the same
username and password pairs. By default, the password of "admin" is "admin", and the password of
"monitor" is "monitor". If the password is changed via the Web-based UI, it will also be changed in the serial
console. In case you lose your password, you can use the username "reset" and password
"DLM-3500_dlink" to log into serial console and reset the system to default.
Open the IE browser to access the Web-based UI
Please Note: Please remember the changed password; otherwise it is not possible to access the DLM-3500
management interface.
DLM-3500 Quick Installation Guide
6