Majestic 5.0 Octave Quantum Marimba Assembly Instruction

Assembly Instruction

4.3 & 5.0 OCTAVES
QUANTUM
MARIMBA
W W W . M A J E S T I C - P E R C U S S I O N . C O M
Ver. 201401
I. Components P1
8 9
6
5
1
7
3
2
11
12
10
4
14 15
18
19
13
16 17
P4
Set the Bass End Leg Assembly upright, cross bars
are horizontal to ground, repeat the process on Treble
End Leg Assembly.
Engage brakes before setting Leg Assembly in upright
position. This will provide stability and traction. Wheels
should be positioned with brakes facing playing side.
(A)
(B)
(C)
P2
Item Parts Description
1 Leg Assembly - Bass End x 1
2 Leg Assembly - Treble End x 1
3 Center Cross Bar x 1
4 Leg support x 2
5 Side Frame – Bass End x 1
6 Side Frame – Treble End x 1
7 Rails (no.1~ no.4) x 4
8 Resonator- Naturals for 4.3 Oct Model x 2
9 Resonator- Accidentals for 4.3 Oct Model x 2
10 Tone Bars-Naturals x 1
11 Tone Bars-Accidentals x 1
12 Protective Cover x 1
13 Mallets x 1
Resonator For 5.0 Oct Model
14 Resonator-Naturals Bass-section x 1
15 Resonator-Accidentals Bass-section x 1
16 Resonator-Naturals Mid-section x 1
17 Resonator-Accidentals Mid-section x 1
18 Resonator-Naturals Treble-section x 1
19 Resonator-Accidentals Treble-section x 1
P5
● Assemble side frames
Standing in the playing posiition with the wheel with
break facing you, set the bass end side frame on top
of the leg assembly. Match the holes with the knob
screws, then tighten with moderate pressure. Repeat
this process at treble end.
Treble End (small end) is to your right, Bass End
(Large End) is to your left.
II. Build the frame P3
Assembly side leg
●
With Bass End Leg Assembly lying flat on the ground,
place the Center Cross Bar in to position (A). Align
hole, insert screw through hole and tighten with the
Allen key provided.
(A)
Place the Frame Bottom Cross Bar w/ Support in Leg
Assembly by connecting to support bar in position (B),
and insert the Cross Bar in position (C). Align hole,
insert screw through hole and tighten with the Allen
key provided.
(B)
(C)
P6
● Assembly rails
Using labels on rails and frame end brackets as guide,
attached rails to corresponding position on the side
frame. Numbering are labeled on bass end of rails and
side frame.
Please begin assembly rails with sequence of
no.3 → no.2 → no.1 → no.4.
For 4.3 Oct Model For 5.0 Oct Model