Draper 3.6V CORDLESS LI-ION SCREWDRIVER KIT Instructions Manual

Table of Contents

Download this manual

Table of Contents

Need help?

Do you have a question about the 3.6V CORDLESS LI-ION SCREWDRIVER KIT and is the answer not in the manual?

Page 7: Health And Safety Information
(230V) into normal operating conditions. If cell is another system of voltage (3.6V) for the sole ruptured hydrogen fluoride and carbon purpose of recharging the Draper 3.6V monoxide may be released. screwdrivers. Any other application is considered misuse.
Page 8 - Blank page -...
Page 9: Unpacking And Checking
Lay the contents out and check them against the parts shown below. If any part is damaged or missing; please contact the Draper Helpline (the telephone number appears on the Title page) and do not attempt to use the lathe.
Page 10: Technical Description
TECHNICAL DESCRIPTION 6.1 IDENTIFICATION LED worklights Trigger switch Forward/reverse selector ¼" female hex. drive Hand grip Charger connection (female)
Page 11: Basic Cordless Screwdriver Operations
BASIC CORDLESS SCREWDRIVER OPERATIONS 8.1 BATTERY CHARGING - FIG. 1 FIG.1 Insert the transformer's jack plug into the charge socket Plug the transformer into a 230V~13 amp 3 pin socket. Note: When complete the LED will extinguish, approximately 3-5 hours. Lithium-ion cells prefer small charges often.
Page 12 BASIC CORDLESS SCREWDRIVER OPERATIONS 8.3 INSTALLING BITS - FIG. 3 FIG.3 Insert the appropriate bit, suitable for the intended application, into the female hex. bit holder NOTE: Will accept 6.35mm (¼") hex. bits only. To prevent slip or damage to the screwhead, match the screwdriver bit to the head size and pattern.
Page 18 RDJP020812...