Mooer PREAMP LIVE Owner's Manual page 6

PEDAL LAYOUT
VOL
01
Adjusts the preamp channel volume
BASS
02
Adjusts the preamp channel low frequencies
MID
03
Adjusts the preamp channel middle frequencies
TREBLE
04
Adjusts the preamp channel high frequencies
GAIN
05
Adjusts the preamp channel gain
BOOST
06
Rotate to adjust the boost level for the preamp channel
Press to change the boost to pre (before the preamp input) or post (after the preamp volume)
Press and hold to access pre and post noise gates. (LED's will turn yellow)
MASTER
07
Adjusts the master output volume of PREAMP LIVE
PRESENCE
08
Adjusts the master presence (brightness) of PREAMP LIVE
FX LEVEL
09
Adjusts the master output level of the effects send
CAB SIM
10
Toggles speaker cabinet simulation on/off. Each output has an independent toggle switch for activating speaker cabinet
simulation. Turn CAB SIM on if this output is being sent direct (DI) to a full frequency monitor, PA system or audio interface.
FOOTSWITCH 1-4
11
See the "Footswitches / Channel selection / Saving Presets"
INPUT
12
Connect your instrument using a standard ¼" jack cable
SEND
13
Connect to your external effects input
RETURN
14
Connect to your external effects output
OUTPUT
15
Connect to a power amp or direct to a PA system or audio interface
GROUND LIFT
16
Use to eliminate ground hum when using XLR OUT
XLR OUT
17
Connect to a power amp or direct to a PA system or audio interface
MIDI IN
18
Connect to an external device's MIDI OUT to remotely control the PREAMP LIVE
MIDI OUT
19
Connect to an external devices MIDI IN to control it using PREAMP LIVE
PHONES
20
Connect directly to your headphones
USB
21
Connect to a computer to change preamp models, programme MIDI settings, edit channel settings using the proprietary
editing software and update PREAMP LIVE's firmware
DC IN
22
Connect to power supply 12V DC 1A
section of this manual for more info...
4