Download  Print this page

Kenmore 100.8910890A Use & Care Manual Page 5

Tilt head 3 & 5 qt.
Hide thumbs

Advertisement

PREPARING TO USE YOUR STAND MIXER
BEFORE FIRST USE:
1. Before using your Stand Mixer, remove all packing material, plastic, labels,
stickers or tags that may be attached to the Mixer, Bowls or Attachments.
2. Before the rst use of the Stand Mixer, wash the Flat Beater, Dough Hook, and
Stainless Steel Bowls in warm, sudsy water or in the dishwasher. The
Wire Whip should be washed by hand only. Rinse and Dry all thoroughly.
3. The exterior of the Stand Mixer should only be cleaned with a soft damp cloth,
then dried with a soft,clean cloth.
4. Place Stand Mixer on a dry, level, stable, surface such as a countertop or
table. Keep Mixer away from countertop edge. Be sure to leave plenty of room
around Air Vents at the rear of Mixer.
NOTE: Do not use abrasive cleansers or scouring pads when cleaning
your Stand Mixer. NEVER immerse the body of the Stand Mixer
in water or any liquid.
OPERATING YOUR STAND MIXER
TILT HEAD
To insert and remove attachments and bowls, it is necessary to raise the Tilting Motor
Head.
To raise Head, locate the Locking lever on the left hand side. Pull lever forward to the
Unlock icon . Raise head and release lever. Lever will return to Lock icon
head all the way back until it stops. Head is now locked in place.
To lower Head, pull lever forward to Unlock icon. Release lever and guide Head
down until it locks into Mix position.
WARNING: To avoid serious injury, never turn on Mixer with Beater or other
attachments connected unless the Bowl is in place.
WARNING: To avoid serious injury, keep
beater attachment hole and hinge area when raising or lowering Tilt Head.
ers and hands away from
5
. Push

Advertisement

Table of Contents

   Also See for Kenmore 100.8910890A

   Related Manuals for Kenmore 100.8910890A

This manual is also suitable for:

100.8920890a100.8900890a100.89218110

Comments to this Manuals

Symbols: 0
Latest comments: