General Owner's Instructions - Kasco 2400D Owner's Manual

3

GENERAL OWNER'S INSTRUCTIONS

INSPECT THE SHIPMENT
Immediately inspect your Kasco De-Icer shipment for any visible damages. Also cross reference the
parts supplied with the Parts Included sheet to check for shortages. Shortages should be reported im-
mediately to your Kasco Marine distributor or representative and damages reported to your carrier and
Kasco Marine.
CAUTION
WARNING: Under NO circumstances should anyone enter the water with the unit in operation.
Always operate the unit in the water and keep people and objects clear of the propeller. Do not lift or
pull the unit by the electrical cord. Always use extreme caution around electrical equipment and wa-
ter situations.
ASSEMBLY & INSTALLATION
Please see the proper Assembly and Installation Instructions enclosed in this manual. Each is specific
for your model and size of De-Icer and De-Icer accessory.
WARRANTY
Kasco De-Icers are the result of over 40 years of design and engineering. Kasco products are built to
withstand the toughest conditions. Kasco Marine backs each De-Icer with a 2 Year Warranty. This
warranty covers any and all manufacturers defects within 2 years from the date of purchase (See War-
ranty, Warranty Claim, & Return Policy on pages 4 & 5). Please register your De-Icer online at:
www.de-icer.com/solutions_warranty_registration.htm .
USE AND OPERATION
Kasco De-Icers are designed and engineered for continuous duty in the harshest environments, such as
in marinas or other commercial applications, or on-demand use, as may be needed.
Your Kasco Marine De-Icer is ready for immediate use (after installation). The motor is of an oil-
filled design with ball bearings submerged in oil and equipment with a thermal overload protection
with an automatic reset. No further lubrication is necessary. It is extremely important that the in-
staller make sure sufficient and proper voltage is available to the unit's motor. The zinc anode located
below the propeller must be in good condition in order to prevent corrosion damage to the unit. The
zinc anode must be inspected periodically and replaced if it shows significant deterioration. Make
sure to keep the motor housing clean from hard water deposits and/or algae. (See Maintenance
Recommendations on page 6.)
The De-Icer is also completely assembled, you do not need bolts, screws, nails, or brackets, unless an
optional mounting device was purchased. All you have to do is suspend it in as little as two (2) feet of
water from piers, docks, or boats and plug it into a 15 amp outlet.
Kasco De-Icers are lightweight, energy efficient, and easy to install and operate. We strive to produce
products that exceed customer expectations. We hope you enjoy your Kasco De-Icer.
Please Note: Under certain conditions, no de-icer can prevent damage from ice movement caused by
wind or current, or from extremely cold weather causing ice to form all the way to the bottom and in
some cases where bottom water temperature is the same as the ice. Effective de-icing can also be re-
tarded when used in extremely shallow conditions.