Kasco 2400D Owner's Manual

Kasco 2400D Owner's Manual

De-icer
Hide thumbs Also See for 2400D:

Advertisement

Replacement Parts Diagram
C
Intertek
3020379
ANSI/UL 778: 2016
Ed.6+R:22Feb2017
CSA C22.2 #108: 2014 Ed.5
De-Icer
Owners Manual
Fax 715-262-4487
sales@kascomarine.com
Contents
U.S.A.
. . . . . .2
. . . . . .2
. . . . . .2
. . . . . .2
. . . . . .3
. . . . . .5
. . . . . .6
. . . . . .7
. . . . . .9
. . . . . .10
. . . . . .11
. . . . . .12
Rev. 02/08/18
824404

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2400D and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kasco 2400D

  • Page 1: Table Of Contents

    Additional Accessories for Your De-Icer ..10 Customer Repair Form ..11 Registration Information ..12 Kasco Marine, Inc. 800 Deere Rd. Prescott, WI 54021 U.S.A. Intertek Phone 715-262-4488...
  • Page 2: Safety Instructions

    Parts Included sheet to check for installation. shortages. Shortages should be reported immediately to your Kasco Marine distributor or representative and Note: Under certain conditions, no de-icer can damages reported to your carrier and Kasco Marine. prevent damage from ice movement caused by wind or current, or from extremely cold weather.
  • Page 3: De-Icer Installation Instructions

    Please Note: Under certain conditions, no de-icer can WARRANTY prevent damage from ice movement caused by wind Kasco De-Icers are the result of over 40 years of or current, or from extremely cold weather causing ice design and engineering. Kasco products are built to to form all the way to the bottom and in some cases withstand the toughest conditions.
  • Page 4 8 to 10 feet surface. Any obstruction at the surface of the water apart. The high starting torque of your Kasco De-Icer may slow or stop the flow of warmer water. A natural...
  • Page 5: Warranty Policy

    After installation and the unit is turned on, your Kasco De-Icer will swing up to an angle (the angle is dependent on how many cage wires you move...
  • Page 6: Maintenance Recommendations

    Once the warranty coverage has been established, the unit and must include a daytime phone number and/or unit may be sent to any Kasco Authorized Repair Cen- e-mail address. Estimate options are as follows: ter for evaluation and repair. Please call Kasco Ma-...
  • Page 7: Troubleshooting Tips

    ZINC ANODE: A Sacrificial Zinc Anode is supplied This can also be a symptom of several possible on the shaft of all Kasco De-Icers for protection of problems. There could be an electrical problem where the equipment from corrosion and electrolysis. The the unit is not getting the proper voltage.
  • Page 8 If something is caught in the unit or there is a build-up on the unit, remove the debris and, if caught early enough, the unit should be fine. Contact a Kasco representative before restarting the unit. “My De-Icer flow seems to fluctuate and/or be less than usual.”...
  • Page 10: Additional Accessories For Your De-Icer

    Additional Accessories for Your De-Icer C-10 Thermostat Control: The C-10 Thermostat Controller is an inexpensive way to control the operation of your Kasco De-icer by Kasco’s heavy duty dock or piling mount is made from using air temperature. The C-10 plugs into a standard corrosion protected steel and stainless steel.
  • Page 11: Customer Repair Form

                                             Customer Repair Form 800 Deere Rd  Prescott, WI 54021  Phone: 715‐262‐4488 Fax: 715‐262‐4487  www.Kascomarine.com   Sales@kascomarine.com    Repair Contact Form   Kasco requires all Repairs sent in MUST be accompanied by this form and marked to Repairs  attention. (ex. Attn: Repairs)    Repairs returned should include upper pump housing or wire basket for Aerators and De‐Icers. These  parts protect the motor during shipping.    Kasco is NOT responsible for shipping damage accrued in return shipment.    It is the responsibility of customer to ship and pay freight to Kasco.    Do not ship float or control panel with unit, unless otherwise instructed   A fee of $60 per hour will be assessed for cleaning excessively dirty units and float disassembly   Refer to the Owner’s manual for easy‐to‐follow troubleshooting rule out site issue.   Note: Contact Information Should be that of the person or company to contact for repair.    Company   First Name  Last Name        Address  City  State     ...
  • Page 12: Registration Information

    Also fill in the information below and keep for your records. Model # (Ex. 3400D)_______________________________ Serial # (Ex. 8001D341725)______________________________ Purchase Date:_____________________ Purchased From:___________________________________ Registration Date: ___________________________ Kasco Marine, Inc. 800 Deere Rd. Prescott, WI 54021 Phone (715) 262-4488 • Fax (715) 262-4487 www.kascomarine.com • www.de-icer.com • sales@kascomarine.com 824404...

This manual is also suitable for:

3400d3400hd4400d4400hd

Table of Contents